Has anyone run ADO’s 1/4" spacer with the Z1 springs, billstein 4600, on stock UCAs? That would put me around 2.25" of lift, and I’m thinking I may get coil bucket contact over 2".
Z1 fine tune spacer says it lifts approx .3 -.4 inches of ride height still putting me over “2.
On stock UCA for now… if I add the lift without the fine tune spacer for now and then add the spacer in a few months, will I need to get another alignment? I’m assuming so bc geometry or something but idk for sure.
Anyone running the spring lift with small spacer on stock UCA and getting CBC or not?
This truck will see forest roads for hunting fishing camping, sometimes the roads are a little sketchy but nothing insane and I’m def not rock crawling. Stock height has been a minor issue with the LWB for me in some areas (bottomed out and I didn’t love it). After the lift I will consider a tranny skid as well.
by ggwpMax
3 Comments
Picture is my stock LWB p4x
For spacers, upgrade the UCA, if you don’t do the spacers and just use the ADO spacer eraser kit, you won’t have cbc.
Fuuuck I’m trying so hard to find a long bed in green right now