I gotta be honest, as much as I love the 1/4in system, I don't like the bits for this tool at all. The angle on the bit holder makes the ball detent system flimsy, and the soft plastic block that holds the other bits makes for a slow and fiddly experience. Has anyone implemented anything better in a pouch-carry kit?
by theflinchburger
2 Comments
Klein double ended bits will fit & you can get them at Amazon & alot of hardware stores (Aliexpress/Temu & such). Alternatively, you can get some 6x1mm magnets & stick a couple into the end of the bit holder & use reg single sided bits where its easy to get anywhere
You can grab a small neodinium magnet and add it to the driver, you do not need a lot of magnetic strength. Mine is wafer thin. Holds the non ball bits great, doesn’t interfere with the balls