So about 6 months ago I disassembled the Frack to clean it (mind you ive done this tons of times with other button locks) but as you can see something is wrong here. Any suggestions?
by StormnTX
So about 6 months ago I disassembled the Frack to clean it (mind you ive done this tons of times with other button locks) but as you can see something is wrong here. Any suggestions?
by StormnTX
2 Comments
You’re missing a stop pin I think, that hole above the button on the inside of the scales is where it would go.
Also that button is seated way higher than it should be.
I’d say talk to cjrb to see if they can send you the part, then reassemble very carefully.
Did you lost a stop pin? Heres a dissasembly video: [https://www.youtube.com/watch?v=qpjFDDCswkg](https://www.youtube.com/watch?v=qpjFDDCswkg)