I’ve been working on a project to replace the housing on a TS10. So far I’ve remade all of the pieces out of 7075 aluminum, except the section with the electronics & emitter. Does anyone know how to non-destructively remove the electronics, or if it’s even possible?
by MikohB
2 Comments
I think it’s glued in. Get some Debonder on there and give it a
Little gentle persuasion from the top with a non metallic implement.
The screw that is accessible from the mcpcb side holds the driver in. Just need to desolder the wires, remove the screw and the driver will pull right out.