New 711L Pen Driver! And some compatibility testing

All photos include the Photo 1: 711L Pen Driver +Geometric)

Photo 1: Packaging that comes with Pen Driver.

Photo 2,3,4&5: Wiha Double Ended Bits (some combo of 2 sets), 3d printed case I made, 4mm bit (stolen from a mini flex companion.

Photo 6: Leatherman Wave+, Leatherman double sided flat bit.

Photo 7: 711L lollipop bit driver (stainless steel red), 711L Flat End Flex Head EDC Ratchet Wrench.

Photo 8: Klein Tools Flip Socket and 1/4-Inch flip socket hex adapter.

Photo 9: Klein Tools Flip Sockets (metric and standard) and 3d printed holder I made.

Photo 10: Same as 8, + the 711L Flat End Flex Head EDC Ratchet Wrench

Brief explaining

• The male hex end on the pen driver is not long enough to reach the magnet on the lollipop driver, causing it easily fall out.
• Next, the orientation of the female end of the pen driver means the ratchet driver will never be parallel with the pen driver.
• Finally, the male end of the pen driver isn't long enough to equip all sizes of the flip sockets. Biggest one worked though.

Photo 11: Steinwhale 2in1 Bits.

DON'T DO IT I sacrificed myself for the sake of science. I did some damage to that bit and just barely was able to pry it out with my knipex cobras. DONT DO IT.

Photo 12: 1/4" hex key. Enough said.

Let me know if you have any quandaries or quibbles. I'll try to quell them with a quality quip.