I have just bought the Sofirn SC13 Copper. Comparing it with the SC13A on moonlight (locked > 1H) the SC13 Copper is just so much brighter. The image is the beamshot of Cu on the left and SC13A on the right; the Cu on moonlight obliterates the SC13A moonlight. Also noticeable is that the SC13A, when ramping down on smooth mode has a distinct jump from the lowest non-floor level to the floor level, the SC13 Cu does not.
Have I disabled the true floor level on the Copper somehow?
I have done a hard reset. I have: gone into advanced (10H); then turned it on (1C); then selected smooth ramp (3C); then gone into the Ramp Config Menu for Floor level (7H, hold for one flash); then entered 1C once the light starts to buzz; then waited until it goes back to a solid light, and then tested 1H from locked and off. It still doesn't lower the ramp floor level, or the moonlight level.
What have I missed? Can anyone help me set a lower moonlight level on the Copper, please?
by bejeb
2 Comments
Afaik the Cu uses a buck driver so it’s moonlight is trash compared to the sc13a which is using a linear driver. Someone more intelligent can explain why a buck driver can’t do moonlight as well.
That said, if the image on left is cu in moonlight appears too bright but maybe it’s the camera settings.
Look up how to set the floor level in anduril.