Civivi klavi. Super fun little knife. After many hours of reading posts and comments on this sub, I finally bought a real knife. Couldn’t be happier with it. Works great for what I use it for. Only complaints I have are it wasn’t sharp and the alignment is off when it’s closed (idk the technical term if there is one). If anyone can lmk how to realign the blade, that would be awesome.
by nobody0411
3 Comments
Try adjusting the tightness of the pivot screw first (probably a Torx8). If that doesn’t work, loosen the pivot screw completely, tighten all the body screws, and then tighten the pivot screw again. Don’t over tighten them too much, as it can strip the head of the screws. I recommend using a bit of blue threadlocker on the pivot screw to keep it in the same position.
[Nick Shabazz technique](https://youtu.be/knxdb8orZwQ?si=RjipeTOXz-DiLiaI) for centering a blade. I can’t say for certain it will work. I usually just send them back if the centering is that bad out of the box.
Since it sounds like you’re new to knives, I highly recommend investing in a good set of torx bits before you start messing with your knife. Wiha or Wera both make good sets
that’s a liner lock, that’s just how those are.